Settings For Transmission; Scan Settings - Muratec MFX-1200 Operating Instructions Manual

Settings for transmission

Scan settings

Default setting: Primary resolution: Normal, Primary contrast: Normal
Two different settings tell your machine how to scan documents. The initial factory
settings are probably right for most applications, so try using them before changing
any of these settings:
Primary resolution mode Sets the resolution for your documents. Choose
either normal, fine, superfine ( S Fine on the
Primary contrast mode Sets how light or dark you want faxed documents
to be when they arrive at their destinations.
Note: The primary settings you choose effect your fax activity only.
To set these modes:
1
Press Program key, , 2, 0, 1,
B
Resolution :Normal
/ /Enter
2
Press or until the mode you want appears. In this example, we ve chosen
fine resolution.
Resolution :Fine
/ /Enter
3
Press to save the setting. The
ENTER
Contrast :Normal
/ /Enter
4
Press or until the mode you want appears. In this example, we ve chosen
light contrast.
Contrast :Light
/ /Enter
5
Press to save the setting.
ENTER
) or grayscale mode ( Gray ).
LCD
. The asks you to select a resolution:
ENTER LCD
asks you to select a contrast setting:
LCD
By following the steps above, you ve set your defaults for scanning. Before sending
documents, you can override these default scan settings for that transmission.
To override the default resolution and contrast settings before sending a document:
Press to change the resolution.
RESOLUTION
Press to change the contrast.
CONTRAST
Once your document is transmitted, your machine returns to its default settings.
Setting
ECM
Default setting: ON.
Line noise, or static on the line during a call, can easily disrupt the flow of data
from one fax machine to another.
That s why your fax machine gives you the option of using Error Correction Mode
( ). When two fax machines communicate while running in
ECM
machine automatically checks the data as it sends. If the receiving fax machine can t
verify the transmission, the first machine will re-send it as necessary.
Note: gives you a better chance of transmitting a fax document over a bad
ECM
phone line, but it could also slow down the transmission time. And the worse
the line is, the slower the transmission. That s why the machine lets you
turn on or off as needed.
ECM
Note: Not all fax machines have
ECM
a fax machine not currently using
transmission from a usual, non-
1
Press Program key, , 2, 0, 9,
B
ting:
E C M Mode :On
/ /Enter
2
Press or until the mode you want appears.
In this example, we ve chosen Off.
E C M Mode :Off
/ /Enter
3
Press to save the setting.
ENTER
Changing the default settings
, the sending
ECM
. If you ve activated and then transmit to
ECM
, there will be no change in the fax
ECM
transmission.
ECM
. The shows the current
ENTER LCD ECM
set-
4.1