How To Install The Fan Tray 0 Cable; Before You Begin; What To Do; I "How To Remove The Fan Tray 0 Cable - Sun Microsystems Sun Fire V490 Parts Installation And Removal Manual
Hide thumbs
Also See for Sun Fire V490:
- Administration manual (276 pages) ,
- Setup and rackmounting manual (64 pages) ,
- Administration manual (274 pages)
Table of Contents
Advertisement
How to Install the Fan Tray 0 Cable
Before You Begin
Complete this task:
"How to Remove the Fan Tray 0 Cable" on page 182
I
What to Do
1. Push the P1 cable end through its hole in the front of the chassis.
2. Route the cable end between the centerplane and the drive bay.
Attach the cable to the cable tie on the side of the disk cage.
3. Connect the P1 cable end to J2302 on the PCI riser board.
4. Using a Phillips No. 2 screwdriver, attach the Fan Tray 0 cable mounting bracket
to the front of the chassis.
184
Sun Fire V490 Server Parts Installation and Removal Guide • October 2005
Advertisement
Table of Contents
