How To Remove The Fc-Al Backplane; Before You Begin; What To Do - Sun Microsystems Sun Fire V490 Parts Installation And Removal Manual

How to Remove the FC-AL Backplane

Before You Begin

Complete these tasks:
"How to Power Off the System" on page 22
I
"How to Remove a Disk Drive" on page 55
I
"How to Slide the System Out of the Cabinet" on page 25
I
"How to Remove the PCI Access Panel" on page 100
I
"How to Avoid Electrostatic Discharge" on page 41
I
"How to Remove Fan Tray 1" on page 103
I

What to Do

1. Disconnect the Fibre Channel-Arbitrated Loop (FC-AL) power cable from J0201 on
the FC-AL backplane.
Press the tab to unlock the cable and pull the cable out of the connector.
Note – For cable routing information, see
page 166.
2. Disconnect the FC-AL data cable from J0200 on the FC-AL backplane.
Push the ejector levers apart to eject the cable from its connector.
3. Loosen the two Phillips No. 1 captive screws on the FC-AL backplane mounting
bracket.
134 Sun Fire V490 Server Parts Installation and Removal Guide • October 2005
"Cable Connections and Routing" on