What Next; How To Remove The System From The Cabinet; Before You Begin - Sun Microsystems Sun Fire V490 Parts Installation And Removal Manual

What Next

To power on the system, see:
"How to Power On the System" on page 18
I
How to Remove the System From the
Cabinet
Sun recommends that you remove the system from the cabinet when doing the
following:
Removing and installing the centerplane
I
Removing and installing the power distribution board
I
Removing and installing the system control switch/power button cable
I
You can perform all other procedures while the system is still attached to the rails
extended from the rack. If you want to remove the system from the cabinet for any
other reason, follow the instructions in this section.
Caution – The chassis is heavy. Two persons are required to remove the system
from the cabinet in the following procedure.

Before You Begin

Complete these tasks:
Identify a helper to assist you in removing the system.
I
Review the steps in the next section with your helper beforehand and discuss
I
how to coordinate your efforts to ensure your mutual safety.
Assemble the correct tools for the procedure. See
I
and Service" on page 18.
Chapter 2 Preparing to Service the System
"Tools Required for Installation
33