What Next; How To Install The System Controller (Sc) Card; Before You Begin - Sun Microsystems Sun Fire V490 Parts Installation And Removal Manual

Caution – Be sure that the AC power cords are disconnected from the system before
removing the SC card.
5. Pull the SC card from its slot on the PCI riser board.
Caution – Do not apply excessive force to one end or one side of the card. Doing so
could damage the card.
Hold the SC card by the faceplate and its opposite edge, and pull up while rocking
the card from end to end until it is freed from its slot.
6. Place the SC card on an antistatic mat.

What Next

To replace the SC card, complete this task:
"How to Install the System Controller (SC) Card" on page 109
I
How to Install the System Controller
(SC) Card
Caution – Before replacing the SC card, be sure that the AC power cords are
disconnected from the system.

Before You Begin

Caution – If you are using an antistatic wrist strap to protect against electrostatic
discharge, connect it to a properly grounded surface, such as a nearby equipment
rack, or a nearby system that is connected to a power source.
Complete this task:
"How to Remove the System Controller (SC) Card" on page 107
I
Chapter 5 Servicing the PCI Riser Board and Related Components 109