2. Disconnect the FC-AL power cable end at J1901 on the PCI riser board.
Press the locking tab on the cable end and pull it off its connector.
What Next
Complete this task:
"How to Install the FC-AL Power Cable" on page 169
I
How to Install the FC-AL Power Cable
Before You Begin
Complete this task:
"How to Remove the FC-AL Power Cable" on page 168
I
What to Do
1. Connect the FC-AL power cable at J1901 on the PCI riser board.
Push the cable end into its connector until the tab locks into place.
Chapter 7 Servicing Cables
169