What Next; How To Remove The Removable Media Assembly; Before You Begin; What To Do - Sun Microsystems Sun Fire V490 Parts Installation And Removal Manual

2. Tighten the two Phillips No. 1 captive screws on the mounting bracket.
3. Connect the FC-AL power cable to the FC-AL backplane at J0201.
Push in the cable until it snaps into place.
4. Connect the FC-AL data cable to the FC-AL backplane at J0200.
Push in the cable until the ejector levers snap into place.

What Next

Complete these tasks:
"How to Install Fan Tray 1" on page 105
I
"How to Install the PCI Access Panel" on page 102
I
"How to Slide the System Into the Cabinet" on page 31
I
"How to Install a Disk Drive" on page 57
I
"How to Power On the System" on page 18
I
How to Remove the Removable Media
Assembly

Before You Begin

Complete these tasks:
"How to Power Off the System" on page 22
I
"How to Slide the System Out of the Cabinet" on page 25
I
"How to Remove the PCI Access Panel" on page 100
I
"How to Avoid Electrostatic Discharge" on page 41
I
"How to Remove Fan Tray 1" on page 103
I

What to Do

1. Disconnect the removable media assembly (RMA) cable from J1001 on the PCI
riser board.
Pull the ejector levers up until the cable unseats from its connector.
Chapter 6 Servicing Miscellaneous Components 137