Front Fan Assembly Tray; Removing The Front Fan Assembly Tray - Sun Microsystems Netra 240 Service Manual

5. Install the server cover.
See "Installing the Server Cover" on page
6. Power on the server.
See "Powering On the Server" on page

Front Fan Assembly Tray

The front fan assembly tray is located behind the rotating service module. The front
fan assembly tray contains two fans, F2 and F3. The entire front fan assembly tray
should be replaced if one of these fans fail.

Removing the Front Fan Assembly Tray

1. Power off the server.
See "Powering Off the Server" on page
2. Remove the server cover.
See "Removing the Server Cover" on page
3. Open the rotating service module.
See "Opening the Rotating Service Module" on page
4. Ensure that the server is properly grounded.
See "Avoiding Electrostatic Discharge" on page
5. Detach the two front fan assembly cables from the system board connectors
(
FIGURE 4-2
56 Netra 240 Server Service Manual • June 2004
).
29.
20.
22.
27.
30.
32.