What To Do - Sun Microsystems Sun Fire V490 Parts Installation And Removal Manual

What to Do

1. Make sure that the AC power cords are disconnected from the back of the system.
2. Remove the PCI riser board access panel.
a. Loosen the two Phillips No. 2 captive screws securing the PCI riser board
access panel to the chassis.
b. Tilt the access panel outward and pull it straight up to remove it from the
chassis.
3. Disconnect the cables from the PCI riser board.
a. Disconnect the FC-AL power cable from J1901.
Press the tab to release the cable end from its connector.
Note – For cable routing information, see
page 166.
b. Disconnect the system control switch/power button cable from J1401.
Press the tab to release the cable end from its connector.
c. Disconnect the removable media assembly (RMA) data cable from J1001.
Pull up the ejector levers until the cable end comes off the connector.
124 Sun Fire V490 Server Parts Installation and Removal Guide • October 2005
"Cable Connections and Routing" on