What Next; How To Slide The System Out Of The Cabinet - Sun Microsystems Sun Fire V490 Parts Installation And Removal Manual

Note – If the system does not return to the ok prompt, it means you did not abort
quickly enough. If this occurs, wait for the system to reboot, force the system to
return to the ok prompt, and repeat Step 7.
9. At the ok prompt, type:
ok boot -r
The boot -r command rebuilds the device tree for the system, incorporating any
newly installed options so that the operating system will recognize them.
10. Turn the control switch to the Locked position, remove the key, and keep it in a
secure place.
This prevents anyone from accidentally powering off the system.

What Next

The system's front panel LED indicators provide power-on status information.
For more information about the system LEDs, see:
"Front Panel LEDs" on page 3
I
How to Slide the System Out of the
Cabinet
This procedure describes placing the system in position for service by sliding it out
of the cabinet without removing it from the rack. All service procedures except
removing and replacing the centerplane and power distribution board can be
performed while the system is still attached to the cabinet.
Note – Sliding the system out of the cabinet is not required for servicing disk drives,
power supplies, or Fan Tray 0.
Chapter 2 Preparing to Service the System 25