What Next - Sun Microsystems Sun Fire V490 Parts Installation And Removal Manual

a. Insert the tabs on the PCI riser board access panel into their corresponding
slots on the chassis.
Insert the bottom edge of the access panel first and rotate the top edge inward.
Push outward from the inside of the access panel until the tabs drop into place.
b. Tighten the two Phillips No. 2 captive screws that secure the PCI riser board
access panel to the chassis.

What Next

Complete these tasks:
"How to Install a PCI Card" on page 115
I
"How to Install the System Controller (SC) Card" on page 109
I
"How to Install Fan Tray 1" on page 105
I
"How to Install the PCI Access Panel" on page 102
I
"How to Slide the System Into the Cabinet" on page 31
I
"How to Power On the System" on page 18
I
Caution – Do not reconnect the AC power cords to the back of the system until
after you have installed the SC card.
128 Sun Fire V490 Server Parts Installation and Removal Guide • October 2005