Before You Begin; What To Do - Sun Microsystems Sun Fire V490 Parts Installation And Removal Manual

Before You Begin

Complete these tasks:
Identify a helper to assist you in installing the system.
I
Review the steps in the next section with your helper beforehand and discuss
I
how to coordinate your efforts to ensure your mutual safety.
Assemble the correct tools for the procedure. See
I
and Service" on page
Caution – When completing a two-person procedure, always communicate your
intentions clearly before, during, and after each step to minimize confusion.
Caution – Unless the cabinet is bolted to the floor, you must extend the cabinet's
anti-tip legs and adjust their stabilizing feet to the floor. You must level and secure
the cabinet to provide a safe working environment.

What to Do

1. Be sure the cabinet is stabilized so that the cabinet cannot move or tip forward.
If there are feet beneath the cabinet to prevent it from rolling, be sure the feet are
fully extended downward to the floor.
Stabilize the cabinet using the stabilizing mechanisms provided with the cabinet.
Refer to the instructions provided with the cabinet.
2. Open (or remove) the cabinet doors.
3. Slide the empty rack slides back into their protective outer glides.
18.
Chapter 2 Preparing to Service the System
"Tools Required for Installation
37