What to Do
1. Disconnect the system control switch/power button cable from J1401 on the PCI
riser board.
Pull the system control switch/power button cable end out from behind the
centerplane-side Fan Tray 1 mounting bracket.
2. Disconnect the Fan Tray 0 power cable from J2302 on the PCI riser board.
Pull the cable out from behind the centerplane-side Fan Tray 1 mounting bracket.
3. Using a Phillips No. 1 screwdriver, remove the two screws securing the media
door assembly to the chassis.
The screws are located under the media door assembly.
Mounting screws
Chapter 6 Servicing Miscellaneous Components
157