3. Press the back panel LED flex circuit onto the back panel.
Be sure the back panel slot is covered with the LED assembly.
Back panel LED flex circuit
4. Peel off the backing paper from the flex-circuit cable end and press it onto the
inside of the chassis.
5. Connect the P2 cable end of the system control switch to the flex-circuit cable end.
What Next
Complete these tasks:
"How to Install the PCI Access Panel" on page 102
I
"How to Slide the System Into the Cabinet" on page 31
I
"How to Power On the System" on page 18
I
How to Remove the Fan Tray 0 Cable
Before You Begin
Complete these tasks:
"How to Power Off the System" on page 22
I
"How to Slide the System Out of the Cabinet" on page 25
I
182
Sun Fire V490 Server Parts Installation and Removal Guide • October 2005