How To Install A Disk Drive; Before You Begin; What Next - Sun Microsystems Sun Fire V490 Parts Installation And Removal Manual

5. Holding the disk drive by the handle, slide the disk drive out of the disk drive
bay.
Note – When you reinstall the disk drive (or a replacement drive), be sure to install
it into the same drive bay as the one from which it was just removed.
6. Place the disk drive on an antistatic mat.

What Next

To install a disk drive, complete this task:
"How to Install a Disk Drive" on page 57
I

How to Install a Disk Drive

This procedure describes the physical installation of a disk drive. The procedure is
different if you are installing a drive using a hot-plug operation. If you want to
perform a disk drive hot-plug installation, see
the Hot-Plug Operation" on page

Before You Begin

For additional information about internal disk drives and configuring disk drive
arrays, see your Sun Fire V490 Server Administration Guide.
You must follow antistatic precautions when handling a disk drive. Complete this
task:
"How to Avoid Electrostatic Discharge" on page 41
I
If you are not performing a hot-plug operation, complete this task:
"How to Power Off the System" on page 22
I
"How to Install a Disk Drive Using
63.
Chapter 3 Servicing the Front Panel Components 57