What Next; How To Install The Power Distribution Board; Before You Begin - Sun Microsystems Sun Fire V490 Parts Installation And Removal Manual

What Next

Complete this task:
"How to Install the Power Distribution Board" on page 153
I
How to Install the Power Distribution
Board
It is mechanically feasible to service the power distribution board with the system
installed in the cabinet. However, it is easier to remove the system from the cabinet
and perform this procedure on a workbench. To remove the system from the cabinet,
see "How to Remove the System From the Cabinet" on page

Before You Begin

Complete this task:
"How to Remove the Power Distribution Board" on page 150
I
Note – Use only the Sun Fire V490 200-240 VAC power distribution board in the
Sun Fire V490 system.
Caution – If you are using an antistatic wrist strap to protect against electrostatic
discharge, connect it to a properly grounded surface, such as a nearby equipment
rack, or a nearby system that is connected to a power source.
Chapter 6 Servicing Miscellaneous Components
33.
153