Sun Microsystems Sun Fire V490 Parts Installation And Removal Manual page 91

2. Type the following luxadm command:
Where c1t1d0s2 is the logical device name for the disk drive. The system dialog
follows the command.
# luxadm remove_device /dev/rdsk/c1t1d0s2
WARNING!!! Please ensure that no file systems are mounted on
these device(s).
All data on these devices should have been backed up.
The list of devices which will be removed is:
1: Device name: /dev/rdsk/c1t1d0s2
Node WWN: 20000020371b1f31
Device Type: Disk device
Device Paths:
/dev/ rdsk/ c1t1d0s2
3. Type c at the prompt to verify the list of devices:
Please verify the above list of devices and
then enter c or <CR> to Continue or q to Quit. [Default: c]:c
stopping: /dev/rdsk/c1t1d0s2.... Done
offlining: /dev/rdsk/c1t1d0s2.... Done
The disk drive is now offline and spun down. The OK-to-Remove LED will light
when the disk drive is ready for you to remove it. In the following figure, the Disk
Drive 1 OK-to-Remove LED is lit.
Note – It may take up to one minute for the drive to come offline and spin down.
Disk Drive 1 OK-to-Remove LED
Chapter 3 Servicing the Front Panel Components 61