How to Remove the IDPROM Module
This section explains how to remove a functioning ID programable read-only
memory (IDPROM) module so that you can install it on a new PCI riser board,
thereby preserving the system's host ID information. If you are replacing a defective
IDPROM module and want to retain the same host ID, consult your authorized Sun
sales representative or service provider for assistance with programming the new
IDPROM module with the existing host ID and Ethernet address.
Before You Begin
Complete these tasks:
"How to Power Off the System" on page 22
I
"How to Slide the System Out of the Cabinet" on page 25
I
"How to Avoid Electrostatic Discharge" on page 41
I
"How to Remove the PCI Access Panel" on page 100
I
"How to Remove Fan Tray 1" on page 103
I
"How to Remove the System Controller (SC) Card" on page 107
I
"How to Remove a PCI Card" on page 112
I
"How to Remove the PCI Riser Board" on page 123
I
What to Do
1. Locate the IDPROM module on the PCI riser board.
IDPROM
Chapter 5 Servicing the PCI Riser Board and Related Components
129