What Next - Sun Microsystems Sun Fire V490 Parts Installation And Removal Manual

2. Insert the RMA partially into the RMA bay.
Insert the sides of the RMA bracket into their corresponding rails in the chassis.
Leave enough clearance to connect the RMA cable to the PCI riser board.
3. Connect the RMA cable to J1001 on the PCI riser board.
a. Make sure that the two ejector levers on either side of the connector on the PCI
riser board are rotated up.
b. Push the cable back toward the rear of the system until the two ejector levers
on the PCI riser board snap into place.
4. Push the RMA all the way into the RMA bay and reattach the RMA faceplate.
Replace the two Phillips No. 1 screws that secure the RMA faceplate to the chassis.

What Next

Complete these tasks:
"How to Install Fan Tray 1" on page 105
I
"How to Install the PCI Access Panel" on page 102
I
"How to Slide the System Into the Cabinet" on page 31
I
"How to Power On the System" on page 18
I
140 Sun Fire V490 Server Parts Installation and Removal Guide • October 2005