"How to Avoid Electrostatic Discharge" on page 41
I
"How to Remove the Power Supply Access Panel" on page 46
I
"How to Remove Fan Tray 0" on page 65
I
"How to Remove the PCI Access Panel" on page 100
I
"How to Remove Fan Tray 1" on page 103
I
What to Do
1. Disconnect the Fan Tray 0 cable end at J2302 on the PCI riser board.
2. Remove the cable from the cable tie on the side of the drive bay.
3. Using a Phillips No. 2 screwdriver, remove the Fan Tray 0 cable mounting bracket
from the front of the chassis.
4. Pull the cable out through its hole in the front of the chassis.
Note – While removing the cable, be careful not to bind the Fan Tray 0 cable end on
the system control switch/power button cable.
What Next
Complete this task:
"How to Install the Fan Tray 0 Cable" on page 184
I
Chapter 7 Servicing Cables
183