Sun Microsystems Sun Fire V490 Parts Installation And Removal Manual page 191

TABLE 7-1
Cable Name and Part Number
System control
switch/power button cable
(F540-5063)
Back panel LED flex circuit
(F370-4388)
Fan Tray 0 cable
(F540-5064)
FC-AL Loop B cables
(F530-3018)
Cable Connections and Routing (Continued)
Routed From
PCI riser board at J1401
(P1)
N/A
PCI riser board at J2302
(P1)
FC-AL backplane at
J0202 ("From Disks")
FC-AL backplane at
J0203 ("To Disks")
Routed To
Media door
Back panel LED flex
circuit connector (P2)
System control
switch/power button
cable
Chassis front panel (P2)
Sun StorEdge PCI Dual
Fibre-Channel Host
Adapter at J4 (RX)
Sun StorEdge PCI Dual
Fibre-Channel Host
Adapter at J3 (TX)
Chapter 7 Servicing Cables
Cable Management Notes
Route between the drive
bay and the centerplane;
attach the P2 cable end
(using the system control
switch/power button
mounting plate) before
connecting the P1 cable
end.
Route along the top edge
of the chassis; use cable
management clips.
Route flex circuit through
its slot in the chassis back
panel.
Route between the drive
cage and the centerplane,
using the cable tie on the
side of the drive cage.
Push the P2 cable end
through its hole in the
chassis front panel.
Route above Fan Tray 1
and other PCI cards.
167