Mitsubishi Stealth 1994 Import Service Manual page 80

FRONT SUSPENSION
(3) To remove the drive shaft (R.H.) from the transaxle, pry
off the shaft using a lever against the protrusion of the
drive shaft.
Caution
Pulling the drive shaft can cause damage to the T.J.
Be sure to use a lever.
INSPECTION
Check the drive shaft boot for damage or deterioration.
l
Check the ball joints for wear or operating condition.
l
Check the spline part for wear or damage.
l
SERVICE POINT OF INSTALLATION
2. INSTALLATION OF DRIVE SHAFT NUT
the specified direction.
(2) After installing the wheel, lower the vehicle to the
ground and finally tighten the wheel bearing nut.
(3) If the position of the cotter pin holes does not match,
tighten the nut up to 260 Nm (188 ft.lbs.) in maximum.
(4) Install the cotter pin in the first matching holes and bend
it securely.