Mitsubishi Stealth 1994 Import Service Manual page 175

BRAKES
D ABS warning light blinks once after the ignition key is turned to the "ON" position. It
illuminates in the "START" position and blinks once again when turned to the "ON" position.
[Explanation]
When power flows, the ABS ECU turns on the
warning light for approximately 1 sec. while it
performs a valve relay test. If there is a break in the
IGNITION
J/B
ABS-ECU 25
Disconnect the hydraulic
unit connector (A-64) and the
ABS-ECU connector (E-l 2).
Inspect the harness side of
both connectors for damage
to individual terminal pins.
Repair terminal pins as
needed.
In the ianition kev "ON"
between terminal No. 25 and
ground indicate battery
positive voltage?
I
,
harness between the ECU and the warning light, the
light illuminates only when the valve relay is off in
the valve relay test, etc.
No
I
ABS warning light and
ECU is broken.
I
I