Mitsubishi Stealth 1994 Import Service Manual page 111

ECS - Service Adjustment Procedures
(4) Check that when the accelerator pedal is operated, the
indications of service data items No. 61 through 64 on the
scan tool change as shown in the following table.
(5) With the simulated vehicle speed at 60 km/h (37 mph) and
90 km/h (56 mph), similarly operate the accelerator pedal
and check that the scan tool indications change over.
Entered simulated
vehicle speed
30 km/h (19 mph)
60 km/h (37 mph)
90 km/h (56 mph)
(6) Check that when the accelerator pedal is released, the
original damping force (SOFT) is restored in less than a
second.
High Speed Sensitive Control Function Check
(2) Check that when the entered simulated vehicle speed is
changed by the scan tool, the indications of service data
items No. 61 through 64 change.
(If the simulated vehicle speed is continuously changed by
t h e 0 a n d a k e y s o f t h e s c a n t o o l , h o w e v e r , t h e
indications of service data items No. 61 through 64 do not
change during the period the 0 or $, key is pressed.)
Changing entered simulated
Acceleration 129 km/h (80 mph)
to 130 km/h (81 mph)
Deceleration 120 km/h (75 mph)
to 119 km/h (74 mph)
Pitching and Bouncing Control Function Check
(1) Select the Tour mode by the ECS switch.
(2) Using the scan tool, check the indications of service data
items No. 61 through 64.
Scan tool indication: SOFT
(3) Remove the G sensor, slowly shake it up and down through
a space of about 5 cm (1.9 in.) with the connector
connected, and check that the indications of service data
items No. 61 through 64 change.
Shake up and down at a speed of a
round trip in a second.
(4) Check that when the G sensor is held stationary, the
original damping force indication (SOFT) is restored.
Accelerator operating condition
Quickly
depress
HARD
MEDIUM
SOFT
vehicle speed
G sensor status
A second later with
pedal depressed
MEDIUM
MEDIUM
Scan tool
indication
SOFT -+ MEDIUM
MEDIUM + SOFT
Scan tool
indication
HARD