Mitsubishi Stealth 1994 Import Service Manual page 78

FRONT SUSPENSION
MB990998
DRIVE SHAFT
REMOVAL AND INSTALLATION
Removal steps
1. Cotter pin
l l
* * 2. Drive shaft nut
3. Lower arm ball joint connection
4. Cotter pin
5. Tie rod end connection
6. Center bearing bracket installation bolt
7. Drive shaft and inner shaft assembly (L.H.)
8. Drive shaft (R.H.)
9. Circlip
(5) Measure to determine whether the end play of the hub
is within the specified limit or not.
Limit: 0.05 mm (.002 in.)
(6) If the starting torque and hub end play are not within the
limit range while the nut is tightened to 200 - 260 Nm
(145 - 188 ft.lbs.), the bearing, hub and/or knuckle have
probably not been installed correctly. Repeat the dis-
assembly and assembly procedure.
1. INSTALLATION OF OIL SEAL (DRIVE SHAFT SIDE)
Drive the oil seal (drive shaft side) into the knuckle until it
contacts the snap ring.
Apply multipurpose grease to the lip of the oil seal.
Grease: MOPAR Multi-mileage Lubricant
43 - 52 ft.lbs.
29 Nm 21 ft.lbs.
Caution
In the case of AWD-vehicles with A.B.S., take care not to
damage the rotor for A.B.S. installed to the B.J. outer race.
Part No. 2525035 or equivalent
/Q&O--
230 Nm
166 ft.lbs.