Mitsubishi Stealth 1994 Import Service Manual page 186

BRAKES
METHOD OF CLEARING DIAGNOSTIC
TROUBLE CODE MEMORY
Caution
When servicing is finished, clear the diagnos-
l
tic trouble code memory
Diagnostic trouble codes cannot be cleared from
memory when the ABS-ECU system is in fail safe
mode. Proceed to diagnosis and repair.
(No. 7 "DIAG. ERASE" in the actuator test is
selected to erase the diagnostic trouble code.)
(2) After clearing, recheck the diagnostic trouble
codes, and check that memory is cleared.
Actuator test specifications
No. Scan tool
display
01
FL VALVE A
02
04
FL VALVE M
05
Drive pattern
Drive solenoid
valve and motor
Solenoid
Solenoid valve and va've
pump motor for
each HU corres-
ponding channel.
<Manual pattern>
Pump
motor
ACTUATOR TEST FUNCTION
The actuator can be forcibly driven in the following
way by using the scan tool.
NOTE
The actuator test cannot be carried out when the
l
ABS ECU system is in fail safe mode.
When using forced drive using the scan tool, the
l
vehicle must be stopped.
During forced drive using the scan tool, forced
l
drive operation is stopped when any wheel
speed reaches 10 km/h (6 mph).
Not used
decrease
Start of forced drive End of forced drive