Mitsubishi Stealth 1994 Import Service Manual page 150

REAR AXLE
When backlash is
I
excessive
(3) Apply multipurpose adhesive to the threaded holes of
the drive gear.
Specified adhesive: MOPAR Part No. 4318031 or 'd ~
(4) Install the drive gear onto the differential case with the
mating marks properly aligned. Tighten the bolts to the
specified torque in a diagonal sequence.
19. PRESS-FITTING OF SIDE BEARING INNER RACE
Press-fit the side bearing inner races to the differential case
by using the special tool.
. FINAL DRIVE GEAR BACKLASH ADJUSTMENT
(1) Using the special tool, temporarily tighten the side
bearing nut until it is in the state just before preloading
of the side bearing.
(2) Measure the final drive gear backlash.
Standard value: 0.11 - 0.16 mm (.004 - .006 in.)
NOTE
Measure at four or more points around the drive gear
circumference.
(3) Using the special tool (MB991367 and MB991385).
adjust the backlash to standard value by moving the
side bearing nut as shown.
NOTE
First turn the side bearing nut for loosening, and then
turn (by the same amount) the side bearing nut for ,d
tightening.
4318032, or equivalent