Mitsubishi Stealth 1994 Import Service Manual page 99

When diagnostic trouble code No. 11 is output
Disconnect G sensor connector.
No. 1 terminal voltage and continuity
between No. 3 terminal and ground
up to specification?
(Sensor power supply and ground)
Standards:
No. 1 terminal 5 V
No. 3 terminal
Continuity provided
I
Yes
Is trouble cleared by replaced G
sensor?
Yes
End
ECS - Troubleshootincl
Check by entering simulated vehicle speed from
scan tool to simulate pitching and
bouncing controls. (Refer to P.2B-16.) Good?
Between No. 1 terminal and No. 54 terminal
Between No. 3 terminal and No. 57 terminal
No
Replace ECS control unit.