Mitsubishi Stealth 1994 Import Service Manual page 177

BRAKES
Check flow connected with wheel
speedsensor
I
Is the resistance value of the wheel
speed sensor part normal?
Standard value:
Front 0.8 - 1.2 k0
Rear 0.6 - 0.8 kR
Yes
Is the resistance value with the ECU
connector normal?
Standard value:
Front 0.8 - 1.2 kR
Rear 0.6 - 0.8 klR
NOTE
When checking with an oscilloscope, first measure voltage
variations in the wheel speed sensor output. (Refer to P.5-58.)
N o ~-
sensor
No
speed sensor circuit is
broken
Is the standard value for
the gap between the wheel
speed sensor and rotor
within the range?
Standard value:
Front 0.3 - 0.9 mm LOI2 -
Yes
Check the output of each
wheel speed sensor with an
oscilloscope, including the
waveform. (Refer to mea-
surement of wheel speed
sensor output voltage
variations on P.5-58.)
Is the output voltage for
each wheel speed sensor
over the standard value and
is the waveform normal?
Yes
No
Recheck if below the
standard value or if the
sensor has a poor wave-
form. Replace sensor or
rotor.