Mitsubishi Stealth 1994 Import Service Manual page 206

Table of Contents

Advertisement

BRAKES - Service Adjustment Procedures
tion hole in the caliper body.
Standard value: 10.0 mm (.39 in.)
Limit: 2.0 mm (.08 in.)
Caution
Replace the pad if worn beyond the limit. At this time,
replace the pads on right and left wheels as a set.
2. Remove the guide pin, lift caliper assembly, slide the
assembly toward the inside of the wheel well until
separated from the lock pin. Support it with a wire, etc.
Caution
The guide pin has been coated with special grease. Do
not wipe off the special grease on the lock pin, and do
not contaminate the lock pin.
3. Remove the following parts from the caliper support.
Using the following method, measure the drag force of the disc
brake after installation of the brake assembly.
4. With the brake assembly removed, use a spring scale to
measure the rotary sliding resistance of the hub in the
forward direction.
5. Install the pad clips to the caliper support in position.

Advertisement

Table of Contents
loading

Table of Contents