Selecting a video source
After connecting a video source to the projector and making sure your port configuration is correct,
you must select it.
1. From the display panel, select INPUT.
2. Navigate the list of input selections until you find a selection that best matches your
configuration.
The range of available input selections depends on the projector model and/or input/output
combinations. When the Default configuration is selected, the following inputs are supported
for each configuration:
•
One-port—HDMI, SDI, DisplayPort, Christie Link, HDBaseT
•
Two-port—DisplayPort, Christie Link
•
Four-port quadrants—SDI
•
One-port dual-input 3D (3D license-specific)—SDI, DisplayPort, Christie Link
When SDVoE is selected, the HDMI, SDVoE, Christie Link, and HDBaseT inputs are supported
for the one-port configuration.
3. To select the input, select Enter.
Christie Eclipse Installation and Setup Guide
020-103331-01 Rev. 1 (04-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
Connecting devices and establishing communication
83