Connecting A Video Source Using Hdbaset; Selecting A Video Source - Christie Roadie D4K40-RGB Installation And Setup Manual

This card may or may not be included with your model. Standard inputs are subject to change. Refer
to the D4K40-RGB Specifications Guide (P/N: 020-102959-XX) for more details.
Related information
TSIC video formats (on page 50)

Connecting a video source using HDBaseT

The HDBaseT port on the IMXB accepts digital video data from HDBaseT sources.
The input configurations listed below are supported.
Input configuration
One-Port
This card may or may not be included with your model. Standard inputs are subject to change. Refer
to the D4K40-RGB Specifications Guide (P/N: 020-102959-XX) for more details.
Related information
HDBase-T video formats (on page 52)

Selecting a video source

After connecting a video source to the projector and making sure your port configuration is correct,
you must select it.
1. From the display panel, select INPUT.
2. Navigate the list of input selections until you find a selection that best matches your
configuration.
The range of available input selections depends on the projector model and/or input/output
combinations. When the Default configuration is selected, the following inputs are supported
for each configuration:
• One-port—HDMI, SDI, DisplayPort, Christie Link, HDBaseT
• Two-port—DisplayPort, Christie Link
• Four-port quadrants—SDI
• One-port dual-input 3D (3D license-specific)—SDI, DisplayPort, Christie Link
When SDVoE is selected, the HDMI, SDVoE, Christie Link, and HDBaseT inputs are supported
for the one-port configuration.
D4K40-RGB Installation and Setup Guide
020-102961-06 Rev. 1 (09-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Connecting devices and establishing communication
Description
Enables connection of one Ethernet cable to the HDBaseT port
on the IMXB. The HDBaseT input supplies the entire video
raster.
Requirements
N/A
46