Selecting A Video Source; Connecting To A Computer Or Server - Christie Mirage SST Installation And Setup Manual

Input configuration Description
One-Port
This card may or may not be included with your model. Standard inputs are subject to change.

Selecting a video source

After connecting a video source to the projector and making sure your port configuration is correct,
you must select it.
1. From the display panel, select INPUT.
2. Navigate the list of input selections until you find a selection that best matches your
configuration.
The range of available input selections depends on the projector model and/or input/output
combinations. When the Default configuration is selected, the following inputs are supported
for each configuration:
• One-port—HDMI, SDI, DisplayPort, Christie Link, HDBaseT
• Two-port—DisplayPort, Christie Link
• Four-port quadrants—SDI
• One-port dual-input 3D (3D license-specific)—SDI, DisplayPort, Christie Link
When SDVoE is selected, the HDMI, SDVoE, Christie Link, and HDBaseT inputs are supported
for the one-port configuration.
3. To select the input, select Enter.

Connecting to a computer or server

Communicate with a remote computer, server, or an existing network using a RJ-45 cable.
The RS232 port located on the IMXB faceplate uses the Christie proprietary protocol and is intended
for Christie accessories or automation controllers only.
For more information, on the serial commands, see the Mirage SST Serial Commands Guide (P/N:
020-103005-XX) .
1. Use an RJ-45 cable to connect the Ethernet hub or switch to the Ethernet port, located on the
projector IMXB faceplate.
2. When using the Christie serial protocol over Ethernet, connect to port 3002.
Mirage SST Installation and Setup Guide
020-102956-08 Rev. 1 (09-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Connecting devices and establishing communication
Enables a connection from an SDVOE source (such as the
Christie Terra Transmitter) and routes it to the backplane
interface. Refer to the signal chart for more information about
what resolution, frame rates, and formats are supported based
on the projector the card is installed in.
Requirements
1 TSIC card
61