Table of Contents
Advertisement
Selecting a video source
After connecting a video source to the projector and making sure your port configuration is correct,
you must select it.
1. From the display panel, select INPUT.
2. Navigate the list of input selections until you find a selection that best matches your
configuration.
The range of available input selections depends on the projector model and/or input/output
combinations. When the Default configuration is selected, the following inputs are supported
for each configuration:
•
One-port—HDMI, SDI, DisplayPort, Christie Link, HDBaseT
•
Two-port—DisplayPort, Christie Link
•
Four-port quadrants—SDI
•
One-port dual-input 3D (3D license-specific)—HDMI, SDI, DisplayPort, Christie Link
When SDVoE is selected, the HDMI, SDVoE, Christie Link, and HDBaseT inputs are supported
for the one-port configuration.
3. To select the input, select Enter.
Connecting an HDMI video source
For the projector to accept digital video data from HDMI sources, plug the HDMI source directly into
the Video Input panel (in the VOM-IF and VOM-HBI Video Input panel images, A shows the HMID 2.0
port and in the VOM-HBI Video Input panel image, L shows the 2.1 port).
For more details on the VOM-IF and VOM-HBI Video Input panels, see Video Input panel (on page 52).
The input configurations listed below are supported.
Input configuration
One-Port
One-Port, Dual-Input 3D
HDMI 2.0 video formats
The following image formats are supported by the two HDMI 2.0 inputs (A in the VOM-IF and VOM-HBI
Video Input panel images).
•
In the tables below all 1920x1200 and 3840x2400 formats only apply to Christie M 4K+25 RGB.
•
In the tables below all 2048x1080 and 4096x1260 formats only apply to Christie Eclipse, Christie
M 4K25 RGB, and Griffyn Series.
•
Frame rates also include fractional 1/1.001 frame rates.
Christie Griffyn Series Installation and Setup Guide
020-103314-12 Rev. 1 (07-2023)
Copyright
©
2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Connecting devices and establishing communication
Description
Enables connection of one HDMI cable. Supports both 2D and 3D frame-packed, top
and bottom. In this configuration, the HDMI input supplies the entire video raster.
May be used for Dual-Input 3D configurations, where HDMI 1 = left eye input and
HDMI 2 = right eye input.
57
Advertisement
Table of Contents
