Connecting A Video Source Using Hdbaset; Selecting A Video Source; Connecting To A Computer Or Server - Christie D4K40-RGB Installation And Setup Manual

This card may or may not be included with your model. Standard inputs are subject to change. Refer
to the 4K40-RGB Specifications Guide (P/N: 020-102959-XX) for more details.
Related information
TSIC video formats (on page 47)

Connecting a video source using HDBaseT

The HDBaseT port on the IMXB accepts digital video data from HDBaseT sources.
The input configurations listed below are supported.
Input configuration
One-Port
This card may or may not be included with your model. Standard inputs are subject to change. Refer
to the 4K40-RGB Specifications Guide (P/N: 020-102959-XX) for more details.
Related information
HDBase-T video formats (on page 49)

Selecting a video source

After connecting a video source to the projector and making sure your port configuration is correct,
you must select it.
1. From the display panel, select INPUT.
2. Navigate the list of input selections until you find a selection that best matches your
configuration.
3. To select the input, select Enter.

Connecting to a computer or server

Communicate with a remote computer, server, or an existing network using a RJ-45 cable.
The RS232 port located on the IMXB faceplate uses Christie-proprietary protocol and is intended for
Christie accessories or automation controllers only.
For more information, on the serial commands, see the 4K40-RGB Serial Commands Guide (P/N:
020-102972-XX) .
4K40-RGB Installation and Setup Guide–D4K40-RGB, Roadie 4K40-RGB
020-102961-03 Rev. 1 (08-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Connecting devices and establishing communication
Description
Enables connection of one Ethernet cable to the HDBaseT port
on the IMXB. The HDBaseT input supplies the entire video
raster.
Requirements
N/A
44