Unit Change; Software Switch Setting; Scan Calibration; Lct Paper Size Setting - Konica Minolta bizhub C250 Service Manual

Hide thumbs Also See for bizhub C250:

Table of Contents

10. Service Mode

Unit Change

• To select who is to replace a unit.

• When the unit life arrives, the warning display is intended for the specific person who

is going to replace the unit.

When "User" is selected

When "Service" is selected: Life warning.

• Upon setup

• The following are the default settings:

Toner Cartridge

Imaging Unit

Waste Toner Box

Punch Dust Box

• To set whether to use the calibration adjustment value set prior to the shipping.

• To be used when CCD unit has bee changed.

After replacing the CCD unit, the default value needs to be set since the calibration

value set for each unit changes to control the differences in reading performance on

each scanner (CCD).

• The default setting is ON.

• When the setting is changed, the function becomes available by turning the

Sub Power Switch OFF and ON again.

• To set the paper size for the LCT

• Use to change the paper size for the LCT.

The default setting depends on the setting made for the applicable marketing area.

: Copying is inhibited.

US, Japan, Others 4

: "User" Service

Field Service Ver. 3.0 Aug. 2006

Europe, Others1/2/3

Table of Contents