Konica Minolta bizhub C250 Service Manual page 265

8. Utility Mode
<Auto Adj. of Stop Position: Front>
Functions • Adjust the document stop position for the first side.
• Check for skew.
Use • Upon setup of the ADF
Setting/
Procedure
<Auto Adj. of Stop Position: Back>
Functions • Adjust the document stop position for the second side.
Use • Upon setup of the ADF
Setting/
Procedure
222
Field Service Ver. 3.0 Aug. 2006
1. Call the Administrator Setting to the
screen.
2. Touch [System Setting] → [Expert
Adjustment] → [ADF Adjustment] →
[Auto Adj. of Stop Position: Front].
3. Set the furnished Chart on the Original
Feed Tray (the side with arrow faces up)
and press the Start key.
4. Make sure that adjustment result is [OK]
4038F3C504DA
and press [SET].
*If adjustment result is [NG],
• Check the document position and cor-
rect it.
• Make a manual adjustment on [Original
Stop Position].
1. Call the Administrator Setting to the
screen.
2. Touch [System Setting] → [Expert
Adjustment] → [ADF Adjustment] →
[Auto Adj. of Stop Position: Back].
3. Set the furnished Chart on the Original
Feed Tray (blank side faces up) and
press the Start key.
4. Make sure that adjustment result is [OK]
4038F3C504DA
and press [SET].
*If adjustment result is [NG],
• Check the document position and cor-
rect it.
• Make a manual adjustment on [Original
Stop Position].