8. Mechanical adjustment
8.4.2
Auto adjust: Sub Scanning Direction 2-Sided stop position
A. Adjustment procedure
1. Set the mode to the Service Mode.
2. Touch [ADF].
3. Touch [Auto Stop Position Adjustment].
4. Touch [Sub Scanning Direction 2-Side].
22
7. Make sure that Result is OK. Then,
8. Touch [END].
9. Touch [Exit] on the Service Mode
If the Result is Unable:
• Check and correct the skew of the
document.
4582F3E519DA
• Manually correct the value of [Position
Correction].
5. Place the chart furnished with the
[1]
NOTE
• Make sure that the blank surface of
the chart faces up.
6. Press the Start key.
4582fs3508c0
7. Check that Result is OK and then
8. Touch [END].
9. Touch [Exit] on the Service Mode
If the Result is Unable:
• Check and correct the skew of the
document.
4582F3E521DA
• Manually correct the value of [Position
Correction].
Field Service Ver. 1.0 Jul. 2005
touch [SET].
screen.
Document Feeder [1] in the docu-
ment feeding tray.
touch [SET].
screen.
4582F3E520DA