Adjustment Of The Folding Position; Adjustment Procedure - Konica Minolta bizhub C250 Service Manual

5. Mechanical adjustment
5.2

Adjustment of the folding position

• The folding position is adjusted by aligning the folding position to the stapling position.
• This adjustment is made in the Service Mode of the main unit. Since the adjustment is
made in increments of 1 mm, this adjustment is useful for eliminating a displacement of
1 mm or more.
• For the effective adjustment of a minimal displacement smaller than 1 mm, refer to
6. Board switch.
See P.40
Adjustment range: - 7 to + 7 mm (Increment: 1 mm)
5.2.1

Adjustment procedure

1. Set A3 or 11 x 17 to the Feed Tray.
2. Touch these keys in this order: [Fold & Staple] → [OK].
3. Set five sheets of A3 or 11 x 17 original (blank paper acceptable) in the Original Tray.
• These five sheets are used for adjustment to minimize variation.
4. Press the Start Key.
5. Set the mode to the Service Mode.
For details of how to display the Service Mode screen, see the Adjustment/Setting of the
main unit service manual.
6. Touch [Finisher].
7. Touch [Half-Fold Position Adj.].
8. Check the finished copies for deviation of the stapling position of from the newly folded
position.
Take the top surface of the finished copies as A, and the under surface as B.
Standard: 0 ± 2 mm
<To + side>
A
B
28
Field Service Ver. 1.0 Jul. 2005
<Standard>
A
B
4583F3E510DA
<To - side>
A
B
4583fs3502c0