Fold & Staple Pos. Adjustment - Konica Minolta bizhub C250 Service Manual

7. Finisher operations
7.3 Fold & Staple Pos. Adjustment
NOTE
Make this adjustment after any of the following procedures has been performed.
• When the crease unit has been replaced.
• When a deviation occurs in the crease.
• When fold angle adjustment has been made.
1. Make a copy in the crease mode. (A3 size)
Exit direction
30
2. Fold the copy fed out along the
crease.
A
3. Check the crease for deviation (Mea-
sure width A).
Specification: 0 ± 1.5 mm
4. When the width A does not fall within
the specified value, conduct the fol-
lowing adjustment.
4511F3C505DA
5. Display the Service Mode screen.
See P.292 of the main unit service man-
ual.
6. Touch [Finisher].
4511F3E522DA
7. Touch [Fold & Staple Pos.Adjust-
ment].
4511F3E525DA
Field Service Ver. 1.0 Aug. 2006