Konica Minolta bizhub C250 Service Manual page 785

4. Sensor Check
4. Sensor Check
4.1 Check procedure
• To allow sensors to be checked for operation easily and safely, data applied to the IC on
the board can be checked on the panel with the main unit in the standby state (including
a misfeed, malfunction, and closure failure condition).
<Procedure>
1. Set the mode to the Service Mode.
2. Touch the [State Confirmation] Check key.
3. Touch the [Sensor Check] key.
4.2 Sensor check list
4.2.1 Sensor check screen
• This is only typical screen which may be different from what are shown on each individ-
ual main unit.
10
Field Service Ver. 1.0 Jul. 2005
4684F3E500DA