Updating The Firmware With The Internet Isw; Out Line; Service Environment; Preparations For Firmware Rewriting - Konica Minolta bizhub C250 Service Manual

Hide thumbs Also See for bizhub C250:

Table of Contents

3. Firmware upgrade

Updating the Firmware with the Internet ISW

• [Internet ISW] is the system which gives the instruction for updating the Firmware with

the control panel of the Copier, so the Copier will automatically receive the Firmware

from the Program Server over a network for updating. With the Internet ISW, the Firm-

ware can be updated when the operator is at the User's without Firmware data.

The following conditions are necessary for using the Internet ISW function.

• The Copier is connected to such a network environment that the Firmware can be down-

loaded on the internet using the ftp or http Protocol.

The "Internet ISW" will not operate under the following conditions.

• Main power switch is set to OFF.

• Sub-power switch is set to OFF.

• When the following setting is set to "ON":

[Administrator Setting] → [Security Setting] → [Enhanced Security Mode]

• The Copier has the job currently performing.

• For using the Internet ISW, the Network parameter, Program Server Address as well as

Firewall Address need to be set to the Copier.

• For details of each setting item, refer to Main Unit Service Manual, Adjustment/Setting

"Internet ISW".

A. Internet ISW Set

1. Call the Service Mode to the screen.

2. Touch [Internet ISW Set] which is available from [Internet ISW].

3. Touch [ON], and touch [END].

• Settings such as Server setting, etc. will be available by selecting "ON" on this

• When the following setting is set to "ON", "ON" cannot be selected on this setting.

[Administrator Setting] → [Security Setting] → [Enhanced Security Mode]

Field Service Ver. 3.0 Aug. 2006

4037F2E621DA

Table of Contents