Printer 4-Color: Poor Color Reproduction - Konica Minolta bizhub C250 Service Manual

Field Service Ver. 3.0 Aug. 2006
18.3.31

Printer 4-Color: poor color reproduction

A. Typical Faulty Images
B. Troubleshooting Procedure
Step Section
Paper
1
Image Transfer Belt
2
Unit
2nd Image Transfer
3
Roller Unit
4
5 IDC Sensor
Image Process
Adjustment → Grada-
6 tion Adjust
(Service Mode)
Image Process
Adjustment → D Max
7
Density
(Service Mode)
Image Process
Adjustment → Stabi-
8
lizer → Reset + Stabi-
lizer (Service Mode)
9
4036fs4058c0
Check Item
Paper is damp.
Terminal is dirty.
Image Transfer Roller is installed
properly.
Image Transfer Roller is dirty or
scratched.
Sensor is dirty.
"Conv. Value" falls within the speci-
fied range as checked through Gra-
dation Adjust.
Max: 0 ± 100
Highlight: 0 ± 60
The problem has been eliminated
through the adjust of D Max Den-
sity.
After the Reset + Stabilizer
sequence has been completed, run
Gradation Adjust.
The problem has been eliminated
through the checks of steps up to 8.
18. Image quality problem
Result Action
YES Change paper to one just
unwrapped from its pack-
age. Install Paper Dehu-
midifying Heater.
YES Clean.
NO Reinstall.
NO Change Image Transfer
Roller Unit.
YES Clean with blower brush.
YES Go to step 9.
NO Go to next step.
NO Go to next step.
NO Change Image Transfer
Belt Unit.
→ Change MFP Control
Board.
→ Change High Voltage
Unit (Image Transfer,
Neutralizing).
509