Konica Minolta bizhub C250 Service Manual page 141

6. Other
[3]
[4]
2. Reinstall the Original Glass.
3. Turn ON the Main Power Switch.
4. Close the Front Door.
5. Carry out the [Cross Direction Adjustment]. If the specifications are not met, loosen the
CCD Unit mounting screws and move the CCD Unit in the sub scan direction as neces-
sary.
See P.306
NOTE
• Hold the CCD Unit by hand when moving it. NEVER use a screwdriver or similar
tool to tap to move it, as a varied distance between the CCD sensor and lens
results.
• When CCD unit is replaced, [Scan Calibration] and [Line Mag Setting] under [Sys-
tem 2] available in Service Mode should be OFF.
98
3. Remove four Screws [3] and Flat
Cable [4], and remove the CCD Unit
[5].
[5]
[3]
4038F2C070DA
B. Reinstallation Procedure
1. Align the CCD Unit with the center of
the graduations as illustrated on the
left and then tighten the four screws.
4038F2C071DA
Field Service Ver. 3.0 Aug. 2006