Mechanical Adjustment; Punch Hole Deviance Adjustment (Pk-510) - Konica Minolta bizhub C250 Service Manual

Hide thumbs Also See for bizhub C250:

Table of Contents

7. Mechanical adjustment

Mechanical adjustment

Make this adjustment after any of the following procedures has been performed.

• When the punch kit has been replaced.

• When the punch kit has been removed.

4349F3C508DA

4512F3C500DA

Field Service Ver. 1.0 Aug. 2006

1. Set the copier into the hole punch

mode and make a 1-sided copy from

a 1-sided original.

2. Fold the output paper in half and

check whether the punch hole posi-

tions are aligned.

Specification: 0 ± 2 mm

3. If the punch hole position is mis-

aligned, adjust with the following pro-

4. Remove the finisher unit right front

5. Loosen the adjustment screw [1],

and move the punch unit [2] forward

or backward to make the adjustment.

6. After the adjustment has been com-

pleted, tighten the adjusting screw.

7. Make a copy and check the punch

hole positions again.

Table of Contents