Return To Stand-By Mode - Ricoh D017 Service Manual

Energy Save
Timer Settings
The user can set these timers with User Tools (System settings > Timer setting)
Panel off timer (10 sec – 240 min): Panel Off Mode, Default setting: 10 sec.
Auto off timer (1 – 240 min): Off/Sleep Mode, Default settings: 1 min.
Normally, Panel Off timer < Auto Off timer. But, for example, if Auto Off timer < or = Panel Off
timer, the machine goes immediately to Off mode when the Auto Off timer expires. It skips
the Panel Off mode.
Example
Panel off: 1 min.
Auto Off: 1 min.
The machine goes to Off mode after 1 minute. Panel Off mode are not used.

Return to Stand-by Mode

Off/Sleep Mode
Recovery time.
Max 6 sec.
Recommendation
We recommend that the default settings should be kept.
If the customer requests that these settings should be changed, please explain that their
energy costs could increase, and that they should consider the effects on the
environment of extra energy use.
If it is necessary to change the settings, please try to make sure that the Auto Off timer
is not too long. Try with a shorter setting first, such as 30 min., then go to a longer one
(such as 60 min.) if the customer is not satisfied.
If the timers are all set to the maximum value, the machine will not begin saving energy
until 240 minutes has expired after the last job. This means that after the customer has
finished using the machine for the day, energy will be consumed that could otherwise be
saved.
If you change the settings, the energy consumed can be measured using SP8941, as
explained below.
SM 7-2 D017/D018/D019/D020/D084/D085