I-Fax Switches - Ricoh D017 Service Manual

4.4.1 I-FAX SWITCHES

No Function
Original Width of TX Attachment File
0 A4
1 B4
2 A3
3-6 Reserved
7 Not used
SM
I-fax Switch 00 (SP No. 1-102-001)
This setting sets the maximum size of the
original that the destination can receive. (Bits
3~7 are reserved for future use or not used.)
0: Off (not selected), 1: On (selected)
If more than one of these three bits is set to "1",
the larger size has priority. For example, if both
Bit 2 and Bit 1 are set to "1" then the maximum
size is "A3" (Bit 2).
When mail is sent, there is no negotiation with
the receiving machine at the destination, so the
sending machine cannot make a selection for
the receiving capabilities (original width setting)
of the receiving machine. The original width
selected with this switch is used as the RX
machine's original width setting, and the
original is reduced to this size before sending.
The default is A4.
If the width selected with this switch is higher
than the receiving machine can accept, the
machine detects this and this causes an error.
95
Bit Switches - 2
Comments
D361/D510