Ricoh D017 Service Manual page 843

Code Meaning
FCE does not detect the
0-55
SG3-V34.
The stored message
data exceeds the
0-56
capacity of the mailbox in
the SG3-V34.
The communication
mode specified in CM/JM
0-70 was not available
(V.8 calling and called
terminal)
The calling terminal fell
back to T.30 mode,
0-74 because it could not
detect ANSam after
sending CI.
The called terminal fell
back to T.30 mode,
because it could not
0-75
detect a CM in response
to ANSam (ANSam
timeout).
The calling terminal fell
back to T.30 mode,
because it could not
0-76
detect a JM in response
to a CM
(CM timeout).
SM
Suggested Cause/Action
FCU firmware or board defective.
SG3-V34 firmware or board defective.
SG3-V34 firmware or board defective.
The other terminal did not have a compatible
communication mode (e.g., the other terminal
was a V.34 data modem and not a fax
modem.)
A polling tx file was not ready at the other
terminal when polling rx was initiated from the
calling terminal.
The calling terminal could not detect ANSam
due to noise, etc.
ANSam was too short to detect.
Check the line connection and condition.
Try making a call to another V.8/V.34 fax.
The terminal could not detect ANSam.
Check the line connection and condition.
Try receiving a call from another V.8/V.34 fax.
The called terminal could not detect a CM due
to noise, etc.
Check the line connection and condition.
Try making a call to another V.8/V.34 fax.
25
Error Codes
D361/D510