Ricoh D017 Service Manual page 848

Error Codes
Code Meaning
5-25 SAF file access error
G3 ECM - T1 time out
6-00 during reception of
facsimile data
G3 ECM - no V.21 signal
6-01
was received
G3 ECM - EOR was
6-02
received
G3 ECM - RTC not
6-04
detected
G3 ECM - facsimile data
frame not received within
6-05
18 s of CFR, but there
was no line fail
G3 ECM -
6-06
coding/decoding error
G3 ECM - PIP/PIN
6-08 received in reply to
PPS.NULL
D361/D510
Suggested Cause/Action
Replace the FCU or EXMEM board.
Try adjusting the rx cable equalizer.
Replace the FCU or NCU.
Check the line connection.
Check connections from the NCU to the FCU.
Check for a bad line or defective remote
terminal.
Replace the FCU or NCU.
Check the line connection.
Check connections from the NCU to the FCU.
Check for a bad line or defective remote
terminal.
Replace the FCU or NCU.
Try adjusting the rx cable equalizer
Cross reference
Rx cable equalizer - G3 Switch 07 (PSTN)
Defective FCU.
The other terminal may be defective.
The other end pressed Stop during
communication.
The other terminal may be defective.
30 SM