ADF mode check
Feed an original through the ADF.
Is the image skewed?
No
Procedure complete.
Procedure A
1.
Remove the rear and left covers, then the left scanner cover.
2.
Check to see if there is a gap between the scanner unit holder and frame at [A].
3.
If there is no gap, the left front section of the scanner unit is lower than the standard
position.
D017/D018/D019/D020/D084/D085
Yes
Do the front and rear
transport rollers feed the
original straight?
No
Do Procedure B below.
6-13
Image Problems
Yes
Change the position of the
right hinge screw to the
longer hole, and make
small position adjustments
that are necessary.
SM